Dell PowerEdge PowerEdge Rack 4820 매뉴얼 - 페이지 4

{카테고리_이름} Dell PowerEdge PowerEdge Rack 4820에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge PowerEdge Rack 4820 9 페이지. Rack mounting equipment shelf
Dell PowerEdge PowerEdge Rack 4820에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (17 페이지), 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 매뉴얼 (10 페이지)

페이지 인쇄

Cabling the Dell™ PowerEdge™ R710

Introduction

This white paper describes recommended cable routing procedures, both with and without the optional Cable

Management Arm (CMA) for the Dell™ PowerEdge™ R710 in the following racks:

•

PowerEdge 4210

•

PowerEdge 2410

•

PowerEdge 4220

•

PowerEdge 2420

If using the optional CMA, following these procedures will allow you to extend the system from the rack for service

without powering down or disconnecting the cables. If not using the CMA, following these procedures will ensure

secure attachment and strain relief of the cables behind the system. For guidelines on how to route cables within

the rack, refer to the Dell White Paper "Best Practices Guide for Rack Enclosures."

Cabling a PowerEdge R710 with CMA

This section details how to cable a PowerEdge R710 using a CMA. If you are cabling the system without the

optional CMA, please refer to "Cabling a PowerEdge R710 Without a CMA" later in this white paper.

Follow the instructions contained in the Rack Installation Guide found in the rail kit to install the server into the

rack and to install the cables. All illustrations in the following sections were created using a PowerEdge R710.

NOTE: The PowerEdge R710 is not compatible with previous‐generation rails and CMAs.

2.1 Installing the Cables to the System

Attach the CMA tray to the back of the rails as described in the CMA Installation Instructions provided in the CMA

kit. Plug in all applicable cables to the rear of the system. Verify that all connections are secure. See Figure 1.

Figure 1: System with Cables Installed

Page 2