Dell UltraSharp UP3218K 분해 매뉴얼 - 페이지 2

{카테고리_이름} Dell UltraSharp UP3218K에 대한 분해 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell UltraSharp UP3218K 6 페이지.
Dell UltraSharp UP3218K에 대해서도 마찬가지입니다: 사용자 설명서 (50 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 서비스 매뉴얼 (14 페이지)

페이지 인쇄

Tear off 7 pieces of aluminum foil. Disconnect the

lamp cable from the connectors of the power board

and panel module. Use a Philips-head screwdriver to

remove 3 screws for unlocking the cooling fans'

protective cover with the middle iron bezel.

(No.1~3 Screw size=M3x4, Torque=3.5~4.5kgfxcm)

aluminum foil for releasing the cooling fans'

Tear off the

cable, then disconnect the cable from the connector.

Use a Philips-head screwdriver to remove four

screws for unlocking the cooling fans. Remove the

cooling fans from the probers.

(No.1~4 Screw size=M2x6, Torque=3.5~4kgfxcm)

aluminum foil

Tear off three pieces of VBH tape on the specific

position as the picture below shown. Disconnect the

function key cable from the connector of the

interface board. Use a Philips-head screwdriver to

remove eight screws for unlocking the middle iron

bezel with the panel module. Remove the middle

iron bezel.

(No.1~8 Screw size=M3x0.5xL4, Torque=4±0.5kgfxcm)

VBH tape

Use a Philips-head screwdriver to remove four

screws for unlocking the bracket with the panel

module. Use a Jip to lift up the bracket, then tear off

the black mylar tape for releasing the LVDS

connectors. Disconnect the LVDS cables from the

connectors of the panel module.

(No.1~4 screw size=M3x0.5xL4, Torque=4

DELL UP3218K

VBH tape

0.5kgfxcm)