Dell 110T VS80 사용자 설명서 - 페이지 17

{카테고리_이름} Dell 110T VS80에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 110T VS80 23 페이지. Dlt, vs and sdlt media handbook

Visual Media Inspection

When to perform a visual inspection

Best practices: Each time a tape is loaded or changed

When a tape cartridge is dropped or subjected to a hard physical shock

When a shipment of tapes shows any sign of shipping damage

If the DLT, DLT VS or SDLT drive becomes inoperable after loading a tape

! If a drive error occurs, inspect the current and previous cartridge used in that drive.

To Inspect a Cartridge

Case: Inspect the case for cracks, chips or signs of damage.

Cartridge: Inspect the exterior of the cartridge for chips, cracks, dents, or missing screws. Gently

shake the cartridge. Listen for rattling or loose pieces.

Cartridge door: Ensure that the door is moveable and the spring is present.

Write Protect Switch: Move switch. It should snap into write-protected mode and write-enabled

mode.

Cartridge Leader: Gently inspect the cartridge leader to verify that it has not been damaged and

is in the correct position.

DLTtape cartridges: Check the height of the leader to ensure that the loop is sticking up

approximately 3/16" (4mm).

Super DLTtape Cartridges: Ensure that the buckle is not bent in or out.

! When inspecting the cartridge leader do not use anything that could leave contamination, such as a pen or

pencil

Reel Locks: Check that both reel locks are visible. Verify operation using a small flat-blade

screwdriver. The reel locks should spring back when released.

Cartridge Hub: Confirm the spring-loaded hub on the bottom of the cartridge is centered. Press

the hub; it will spring back if operating properly.

Dell DLT, VS and SDLT Media Handbook

Page 17