Dell 110T VS80 Руководство пользователя - Страница 17

Просмотреть онлайн или скачать pdf Руководство пользователя для Хранение Dell 110T VS80. Dell 110T VS80 23 страницы. Dlt, vs and sdlt media handbook

Visual Media Inspection

When to perform a visual inspection

Best practices: Each time a tape is loaded or changed

When a tape cartridge is dropped or subjected to a hard physical shock

When a shipment of tapes shows any sign of shipping damage

If the DLT, DLT VS or SDLT drive becomes inoperable after loading a tape

! If a drive error occurs, inspect the current and previous cartridge used in that drive.

To Inspect a Cartridge

Case: Inspect the case for cracks, chips or signs of damage.

Cartridge: Inspect the exterior of the cartridge for chips, cracks, dents, or missing screws. Gently

shake the cartridge. Listen for rattling or loose pieces.

Cartridge door: Ensure that the door is moveable and the spring is present.

Write Protect Switch: Move switch. It should snap into write-protected mode and write-enabled

mode.

Cartridge Leader: Gently inspect the cartridge leader to verify that it has not been damaged and

is in the correct position.

DLTtape cartridges: Check the height of the leader to ensure that the loop is sticking up

approximately 3/16" (4mm).

Super DLTtape Cartridges: Ensure that the buckle is not bent in or out.

! When inspecting the cartridge leader do not use anything that could leave contamination, such as a pen or

pencil

Reel Locks: Check that both reel locks are visible. Verify operation using a small flat-blade

screwdriver. The reel locks should spring back when released.

Cartridge Hub: Confirm the spring-loaded hub on the bottom of the cartridge is centered. Press

the hub; it will spring back if operating properly.

Dell DLT, VS and SDLT Media Handbook

Page 17