Dell EMC Integrated Data Protection Appliance DP4400 하드웨어 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dell EMC Integrated Data Protection Appliance DP4400에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC Integrated Data Protection Appliance DP4400 18 페이지. Emc integrated data protection appliance

페이지 인쇄
Dell EMC Integrated Data Protection Appliance DP4400 하드웨어 설치 매뉴얼

Prepare the site and unpack the system

Before you begin
Verify that you have the following components:
2U DP4400 system
l
Rail kit, including:
l
Two sliding rails
n
Two velcro straps
n
Four screws
n
Four washers
n
Two power cables
l
Bezel
l
Phillips-head screwdriver with magnetic tip (not provided)
l
Qualified Ethernet cables:
l
Type of switch
10Gb SFP+
1Gb or 10Gb RJ45
1Gb or 10Gb RJ45
Anti-static wrist strap and conductive foam pad
l
You must have a computer at the install location with:
A power adapter, C13 to NEMA 5–15 (if based in North America or country
l
specific cord in other geographical locations), or a power cord for your laptop
power adapter with a C13 plug, to power your laptop from a rack PDU
An Ethernet port
l
Latest version of Google Chrome or Mozilla Firefox
l
Note
Ensure that ICMP (ping) is enabled in the customer environment during IDPA
installation.
The following steps must be completed before starting initial configuration with the
Appliance Configuration Manager:
Procedure
1. Identify 13 unassigned IP addresses for the IDPA components. To simplify
configuration, select a range of 13 contiguous addresses.
NIC Type
Speed
SFP+ (optical)
10Gb
SFP+ with 1GbBASE-
1Gb
T GBIC
10GbBASE-T (RJ45)
1Gb or 10Gb
(depending on the
switch)
Prepare the site and unpack the system
Cable Required
LC-to-LC with SR
optical GBICs or
twinax
UTP with RJ45
(Cat5e or Cat6)
UTP/STP with RJ45
(Cat6a or Cat7)
3