Dell EMC Integrated Data Protection Appliance DP4400 Hardware Installation Manual - Page 3
Browse online or download pdf Hardware Installation Manual for Storage Dell EMC Integrated Data Protection Appliance DP4400. Dell EMC Integrated Data Protection Appliance DP4400 18 pages. Emc integrated data protection appliance
Print Page
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
Prepare the site and unpack the system
Before you begin
Verify that you have the following components:
2U DP4400 system
l
Rail kit, including:
l
Two sliding rails
n
Two velcro straps
n
Four screws
n
Four washers
n
Two power cables
l
Bezel
l
Phillips-head screwdriver with magnetic tip (not provided)
l
Qualified Ethernet cables:
l
Type of switch
10Gb SFP+
1Gb or 10Gb RJ45
1Gb or 10Gb RJ45
Anti-static wrist strap and conductive foam pad
l
You must have a computer at the install location with:
A power adapter, C13 to NEMA 5–15 (if based in North America or country
l
specific cord in other geographical locations), or a power cord for your laptop
power adapter with a C13 plug, to power your laptop from a rack PDU
An Ethernet port
l
Latest version of Google Chrome or Mozilla Firefox
l
Note
Ensure that ICMP (ping) is enabled in the customer environment during IDPA
installation.
The following steps must be completed before starting initial configuration with the
Appliance Configuration Manager:
Procedure
1. Identify 13 unassigned IP addresses for the IDPA components. To simplify
configuration, select a range of 13 contiguous addresses.
NIC Type
Speed
SFP+ (optical)
10Gb
SFP+ with 1GbBASE-
1Gb
T GBIC
10GbBASE-T (RJ45)
1Gb or 10Gb
(depending on the
switch)
Prepare the site and unpack the system
Cable Required
LC-to-LC with SR
optical GBICs or
twinax
UTP with RJ45
(Cat5e or Cat6)
UTP/STP with RJ45
(Cat6a or Cat7)
3