Dell EMC Integrated Data Protection Appliance DP4400 Hardware Installation Manual - Page 13
Browse online or download pdf Hardware Installation Manual for Storage Dell EMC Integrated Data Protection Appliance DP4400. Dell EMC Integrated Data Protection Appliance DP4400 18 pages. Emc integrated data protection appliance
Print Page
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
Configure iDRAC
Installing the DataProtection-ACM pre-installation patch
2. If the system does not power on automatically after connecting the power
cables, press the power button on the right control panel at the front of the
chassis to power on the system .
The IDPA systems require that the Integrated Dell Remote Access Controller (iDRAC)
is configured for system upgrade and maintenance operations. Additionally, the
systems support the use of iDRAC to change security settings and enables to remotely
power the system on and off.
Before you begin
Connect to the unit using a VGA monitor with a keyboard or a serial port, power on the
appliance, and perform the following steps:
Note
Do not use iDRAC to change the storage configuration, system settings, or BIOS
settings, as making changes to these will impact the system functionality. Contact
Support if changes are required in any of these areas.
Procedure
1. During the system boot process, press F2 to access the BIOS menu.
2. In the System Setup Main Menu page, click iDRAC Settings.
The iDRAC Settings page is displayed.
3. Click Network.
The Network page is displayed.
4. Under IPv4 Settings, specify static IP address details.
5. Press Esc to return to the previous menu.
6. Select User Configuration.
a. Enable the root user.
b. Change the root user password.
Note that the default password is Idpa_1234 .
Before you configure the DataProtection-ACM virtual machine, install the latest IDPA
pre-installation patch if it is available.
For example:
Idpa_pre_update_N.N.N-nnnnnn.tar.gz
N.N.N is the latest pre-installation patch version and nnnnnn is the build
Where
number.
Configure iDRAC
13