Dell EMC Integrated Data Protection Appliance DP4400 Hardware Installation Manual - Page 11
Browse online or download pdf Hardware Installation Manual for Storage Dell EMC Integrated Data Protection Appliance DP4400. Dell EMC Integrated Data Protection Appliance DP4400 18 pages. Emc integrated data protection appliance
Print Page
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
Connect the system to the network
Figure 7 Installing the front bezel
The following figure shows the location of the DP4400 network ports and iDRAC port.
Figure 8 DP4400 network and iDRAC connections
Procedure
1. Use a Cat5e or Cat6 UTP copper Ethernet cable to connect a 1 GbE port (10) to
the service computer.
2. If the DP4400 contains 10Gb BASE-T network cards, use Cat6a UTP or Cat7
copper cables to connect to the network switch.
3. If the DP4400 contains 10GB SFP network cards, use fiber cables with a 10 Gb
optical SFP, 1GBaseT RJ-45 SFP with Cat5e or Cat6 UTP copper Ethernet
cables, or direct-attached copper cables to connect the four required 10 GbE
ports (2, 3, 8, 9) to access ports on the switch in your network.
Connect the system to the network
11