Dell EMC VxFlex Ready Node R840 소유자 매뉴얼 - 페이지 38
{카테고리_이름} Dell EMC VxFlex Ready Node R840에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC VxFlex Ready Node R840 44 페이지.
페이지 인쇄
System diagnostics and indicator codes
Drive indicator codes
The LEDs on the drive carrier indicate the state of each drive. Each drive carrier in your system has two LEDs: an
activity LED (green) and a status LED (bicolor, green/amber). The activity LED flashes whenever the drive is accessed.
The status LED indicator indicates the power condition of the drive.
Figure 10 Drive indicators on the drive and the mid drive tray backplane
1.
Drive activity LED indicator
2.
Drive status LED indicator
3.
Drive capacity label
Note:
If the drive is in the Advanced Host Controller Interface (AHCI) mode, the status LED indicator does not turn
on.
Table 30 Drive indicator codes
Drive status indicator code
Flashes green twice per second
Off
Flashes green, amber, and then turns off
Flashes amber four times per second
Flashes green slowly
Solid green
Flashes green for three seconds, amber for three seconds,
and then turns off after six seconds
R840xd Owner's Guide
38
Condition
Identifying drive or preparing for removal.
Drive ready for removal.
Note:
The drive status indicator remains off until all drives are
initialized after the system is turned on. Drives are not ready for
removal during this time.
Predicted drive failure.
Drive failed.
Drive rebuilding.
Drive online.
Rebuild stopped.