Dell EqualLogic PS5500 하드웨어 매뉴얼 - 페이지 13

{카테고리_이름} Dell EqualLogic PS5500에 대한 하드웨어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EqualLogic PS5500 50 페이지. Equallogic ps series iscsi storage arrays with microsoft windows server failover clusters
Dell EqualLogic PS5500에 대해서도 마찬가지입니다: 유지 관리 매뉴얼 (8 페이지)

페이지 인쇄

Figure 4. Example of Network Cabling Connection

1. public network

2. cluster node 1

3. public network adapter

4. private network adapter

For Public Network

Any network adapter supported by a system running TCP/IP may be used to connect to the public network segments.

You can install additional network adapters to support additional public network segments or to provide redundancy in

the event of a faulty primary network adapter or switch port.

For Private Network

The private network connection to the nodes is provided by a different network adapter in each node. This network is

used for intra-cluster communications. The following table describes the two possible private network configurations.

Method

Network switch

Point-to-Point (two-node

clusters only)

Hardware Components

Gigabit or 10 Gigabit Ethernet

network adapters and switches

Copper Gigabit network adapters

with RJ-45 connectors

Copper 10 Gigabit Ethernet network

adapters with RJ-45 connectors

Copper 10 Gigabit Ethernet network

adapters with SFP+ connectors

5. private network

6. cluster node 2

Connection

Depending on the hardware, connect the CAT5e

CAT6, CAT6a, or CAT7 cables, the multi-mode

optical cables with Local Connectors (LCs), or the

twinax cables from the network adapters in the

nodes to a switch.

Connect a CAT5e or better (CAT6, CAT6a, or CAT7)

Ethernet cable between the network adapters in

both nodes.

Connect a CAT6 or better (CAT6a or CAT7) Ethernet

cable between the network adapters in the nodes.

Connect a twinax cable between the network

adapters in both nodes.