Dell PowerVault 50F 연결 매뉴얼 - 페이지 20

{카테고리_이름} Dell PowerVault 50F에 대한 연결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 50F 38 페이지. Dell powervault 56f switches rack installation guide
Dell PowerVault 50F에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 사용자 설명서 (42 페이지), 랙 설치 매뉴얼 (28 페이지)

페이지 인쇄

3-2

Dell PowerVault 5xF Switches Zoning Guide

Enable the configuration.

Test the configuration.

7 .

Save the configuration again.

NOTE: Before issuing any zoning commands, use the switchShow command on

each switch in the zoned fabric to verify that all switches in the fabric are connected.

All ports used for interswitch links (ISL) display the neighboring switches' worldwide

name (WWN) and switch name.

( &

Use the following syntax to add multiple items to a zone:

zoneAdd "name_of_zone", "member; member; member"

For example, zoneAdd "

domain 1, port 12 to zone "Red_zone".

Apply the same syntax when adding aliases (aliAdd) or configurations (cfgAdd).

Members are separated by semicolons but within a single pair of quotes.

The following commands can take multiple-item parameter lists:

Configuration commands, such as cfgCreate, cfgAdd, and cfgRemove

Zone commands, such as zoneCreate, zoneAdd, and zoneRemove

Alias commands, such as aliCreate, aliAdd, and aliRemove

( )*)

A new switch is a switch that has not previously been connected to a fabric with zon-

ing configured and that has had no zone configuration data entered into it. You can

return a switch to the "new" state by using the cfgClear command before connecting

it to the fabric. For zoning purposes, other parameters, such as IP addresses, remain

unchanged.

( !

When you connect a new switch to a fabric, all zone configuration data is immediately

copied from the fabric into the new switch. If a zone configuration is enabled in the

fabric, then the same configuration becomes enabled in the new switch. After this

operation, the cfgShow command displays the same output on all switches in the

fabric, including the new switch.

NOTE: When connecting two switches using ISLs to form a fabric, if there is a differ-

ence in the configuration information relating to any zone objects (aliases, zones, or

configurations) with the same name, the switches cannot connect—even if none of

the defined configurations are enabled.

", "1,10;1,12" adds domain 1, port 10 and