Dell PowerVault 715N 서비스 매뉴얼 - 페이지 19

{카테고리_이름} Dell PowerVault 715N에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 715N 44 페이지. Network attached storage
Dell PowerVault 715N에 대해서도 마찬가지입니다: 업데이트 지침 (4 페이지), 사용자 설명서 (31 페이지)

페이지 인쇄

To remove the control panel assembly, perform the following steps.

CAUTION:

Read the safety instructions in your System Information document.

1. Turn off the system.

Remove the

bezel.

3. Disconnect the system power cables from their electrical outlets.

4. Remove the

system

5. Disconnect the ribbon cable from connector JP5 on the midplane board (see

6. Using a #0 Phillips screwdriver, remove the two screws that secure the control panel to the chassis.

7. Push the ribbon cable forward until the control panel comes out of the front of the system chassis.

8. Disconnect the ribbon cable from the control panel board.

Cooling Fan

A single fan assembly is mounted beside the microprocessor and heat-sink socket. This cooling fan directs cooling air

across the microprocessor and heat sink and across the memory modules and the PCI expansion card before exiting the

chassis through holes in the back panel.

CAUTION:

Read the safety instructions in your System Information document.

Removing the Fan Assembly

If you observe that a fan is not operating or if the server management application issues a fan-related error message,

perform the following steps to replace the faulty fan:

1. Turn off the system.

Remove the

bezel.

3. Disconnect the system power cables from their electrical outlets.

Remove the system

5. Lift the fan assembly out of the chassis carefully, making sure that the connector disconnects from the system

board (see

Figure

cover.

7).

Figure

6).