Dell PowerVault 715N 서비스 매뉴얼 - 페이지 21
{카테고리_이름} Dell PowerVault 715N에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 715N 44 페이지. Network attached storage
Dell PowerVault 715N에 대해서도 마찬가지입니다: 업데이트 지침 (4 페이지), 사용자 설명서 (31 페이지)
페이지 인쇄
System Board and Midplane Board Removal
CAUTION:
Read the safety instructions in your System Information document.
1. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
2.
Remove the
bezel.
3.
Remove the system
4.
Remove the fan
assembly.
5. Pull each hard-drive carrier partially out of its slot, approximately 2.5 cm (1 inch).
6. Label and disconnect the
7. Disconnect the two
8. Remove all external peripheral cables from their connectors at the back of the system.
9. Record the locations and remove all internal cables attached to the system board.
10.
Remove the expansion
11.
Remove the riser
12. Release the
side latches on each end of the midplane
13. Press the
center release latch tab
The latch pivots away from the midplane board.
14. Unscrew the thumbscrew securing the system board to the chassis floor.
15. Slide the system board and midplane board toward the front of the system chassis about 6.3 mm (0.25 inch).
16. Carefully pivot the system board and midplane board up and out of the chassis.
Be sure to lift the midplane board first, and when it is free of the chassis, pull the system board away from the
back panel.
17. Place the system board and midplane board on a smooth, antistatic surface.
18.
Remove the
microprocessor.
19. Remove the
memory
System Board and Midplane Board Replacement
1. Pivot the system board and midplane board assembly into the chassis, first lowering the system board end, and
then lowering the midplane board. When the midplane board reaches the chassis floor, slide the assembly to the
rear about 6.3 mm (0.25 inch).
The grounding pins enter their holes on the system board and the serial port connector protrudes from its opening
in the back panel.
2. Tighten the thumbscrew to secure the system board to the chassis floor.
3. Lock the
side latches
4. Pivot the center release latch tab toward the midplane until it locks in place with a click.
5. Install the
memory
6.
Install the
microprocessor.
7. Ensure that the system board jumpers and switches are set to the same settings as the board you removed.
8. Connect the two DC power cables to their
cover.
control panel ribbon cable attached to the midplane board
DC power cables from their power input connector on the system
card, if one is installed.
card.
toward the midplane while pulling on the latch's right edge.
modules.
on each end of the midplane board.
modules.
board.
power input connectors (CN1 and CN2)
(JP5).
board.
on the system board.