Dell PowerVault LTO-3-060 사용자 설명서 - 페이지 34
{카테고리_이름} Dell PowerVault LTO-3-060에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault LTO-3-060 37 페이지. Powervault tape systems
Dell PowerVault LTO-3-060에 대해서도 마찬가지입니다: 설정 (2 페이지), 핸드북 (28 페이지)
페이지 인쇄
Figure 11
shows the LTO Ultrium 400-GB Data Cartridge and its components.
Figure 11. LTO Ultrium 400-GB Data Cartridge
1. LTO cartridge memory
2. Label area
3. Write-protect switch
4. Insertion guide
5. Cartridge door
6. Leader pin
Loading a Tape Cartridge
1. Ensure that the tape drive is powered on (the Ready light is solid green).
2. Ensure that the write-protect switch (see number 3 in
3. Grasp the cartridge so that the write-protect switch faces you.
4. Slide the cartridge into the tape load compartment (see
If the cartridge is already in the ejected position and you want to reinsert it, remove the cartridge and then insert it again.
¡
If the cartridge is already loaded and you cycle the power (turn it off, then on), the tape will rewind to the beginning and position itself ready for use.
¡
Figure 12. Loading
Unloading a Tape Cartridge
1. Ensure that the tape drive is powered on (the Ready light is solid green).
2. Press the eject button (see number 1 in
rewinds, then goes out before the cartridge partially ejects.
3. After the cartridge partially ejects, grasp the cartridge and remove it.
Whenever you unload a tape cartridge, the tape drive writes any pertinent information to the cartridge memory.
NOTICE: Do not remove a tape cartridge while the drive activity LED is on.
Setting the Write-Protect Switch on Tape Cartridges
NOTICE: Write-protection will not prevent a cartridge from being erased or degaussed. Do not bulk erase Ultrium format cartridges. This will destroy
prerecorded server information and render the cartridge unusable. Always use the long or quick erase command in your backup software to erase
cartridges.
Figure
11) is properly set. (See
Figure 12).
Figure
2). The drive rewinds the tape and partially ejects the cartridge. The Activity light flashes green while the tape
"Setting the Write-Protect Switch on
Cartridges").