Dell PowerVault MD3000i 교체 매뉴얼 - 페이지 3

{카테고리_이름} Dell PowerVault MD3000i에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3000i 4 페이지. Configuration for vmware esx server software
Dell PowerVault MD3000i에 대해서도 마찬가지입니다: 튜닝 매뉴얼 (32 페이지), 지원 참고 사항 (22 페이지), 업그레이드 매뉴얼 (28 페이지), 사용자 설명서 (46 페이지), 구성 매뉴얼 (10 페이지)

페이지 인쇄

Updating RAID Controller and NVSRAM Firmware

on the Replacement RAID Controller Module

The following procedure is required only if a single controller storage array enters

lockdown mode after replacement of a failed controller.

To update the RAID controller module and NVSRAM firmware, the following

items will be required:

•

Server, workstation, or laptop computer with access to the management port

of the RAID controller module

•

Single Controller Replacement Utility

Using the Single Controller Replacement Utility

NOTE:

The Single Controller Replacement Utility will not update any RAID controller

that is not in lockdown mode. If your RAID controller is not in lockdown mode, use the

update procedure described in the Dell

NOTE:

In order to update the firmware, the RAID enclosure must contain at least two

disk drives.

The Single Controller Replacement Utility should be run after replacing a failed

controller in a single-controller system. The utility ensures that the firmware

version in the replacement controller is in sync with the firmware expected by the

virtual disks. After running the utility, the storage array should return to the

configuration it was in prior to the controller failure.

The utility can be run from any computer with access to the management port of

the storage array by following these steps:

1 Extract all files and folders from the utility .zip file to a temporary location.

2 Navigate to the location of the extracted files.

If you are using a Windows system, run the simplex.bat file.

If you are using a Linux system, execute the simplex.sh file.

A GUI-based wizard will guide you through the remaining steps necessary to

update the controller.

3 When the wizard completes, click Finish.

The update process is complete.

PowerVault

MD3000i User's Guide.