Dell PowerVault MD3000i Instrukcja wymiany - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Przechowywanie Dell PowerVault MD3000i. Dell PowerVault MD3000i 4 stron. Configuration for vmware esx server software
Również dla Dell PowerVault MD3000i: Instrukcja strojenia (32 strony), Uwaga dotycząca wsparcia (22 strony), Instrukcja aktualizacji (28 strony), Podręcznik użytkownika (46 strony), Podręcznik konfiguracji (10 strony)

Updating RAID Controller and NVSRAM Firmware

on the Replacement RAID Controller Module

The following procedure is required only if a single controller storage array enters

lockdown mode after replacement of a failed controller.

To update the RAID controller module and NVSRAM firmware, the following

items will be required:

•

Server, workstation, or laptop computer with access to the management port

of the RAID controller module

•

Single Controller Replacement Utility

Using the Single Controller Replacement Utility

NOTE:

The Single Controller Replacement Utility will not update any RAID controller

that is not in lockdown mode. If your RAID controller is not in lockdown mode, use the

update procedure described in the Dell

NOTE:

In order to update the firmware, the RAID enclosure must contain at least two

disk drives.

The Single Controller Replacement Utility should be run after replacing a failed

controller in a single-controller system. The utility ensures that the firmware

version in the replacement controller is in sync with the firmware expected by the

virtual disks. After running the utility, the storage array should return to the

configuration it was in prior to the controller failure.

The utility can be run from any computer with access to the management port of

the storage array by following these steps:

1 Extract all files and folders from the utility .zip file to a temporary location.

2 Navigate to the location of the extracted files.

If you are using a Windows system, run the simplex.bat file.

If you are using a Linux system, execute the simplex.sh file.

A GUI-based wizard will guide you through the remaining steps necessary to

update the controller.

3 When the wizard completes, click Finish.

The update process is complete.

PowerVault

MD3000i User's Guide.