Dell PowerVault MD3600i Series 설치 매뉴얼 - 페이지 15

{카테고리_이름} Dell PowerVault MD3600i Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3600i Series 18 페이지. Storage arrays
Dell PowerVault MD3600i Series에 대해서도 마찬가지입니다: 지원 매트릭스 (12 페이지), 지원 매트릭스 (11 페이지), 지원 매트릭스 (17 페이지)

페이지 인쇄

Managing the SMI-S Provider

Starting and Stopping the OpenPegasus CIM Server

Windows-Based Operating Systems

To start or stop the OpenPegasus CIM server:

•

Open the Services window and locate the cimserver service. Right-click

cimserver service and select start or stop.

•

In the command prompt type:

net start cimserver to start a service

net stop cimserver to stop a service

Linux-Based Operating Systems

To start or stop the OpenPegasus CIM server, on a terminal window type:

cimserver to start a service

cimserver -s to stop a service

Adding or Removing a Storage Array From the

SMI-S Provider

During installation, you are prompted to enter the IP addresses into a file.

After this initial setup, the SMI-enabled client must use the SMI-S Provider

proxy server system management profile to add or remove devices.

NOTE:

When a storage array is added, the IP address of only one of the

management ports of the storage array must be supplied (and not both

management ports). Entering the IP addresses for both management ports of a

single storage array causes unpredictable behavior of the SMI-S Provider.

Managing the SMI-S Provider