Dell PS-M4110 매뉴얼 - 페이지 15
{카테고리_이름} Dell PS-M4110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PS-M4110 22 페이지. Blade array
페이지 인쇄
Create the stack on switch 2:
Put ports into stacking mode. Ports 17-20 were used as
stacking ports.
console#configure
console(config)#stack
console(config-stack)#stack-port tengigabitethernet 2/0/17 stack
console(config-stack)#stack-port tengigabitethernet 2/0/18 stack
console(config-stack)#stack-port tengigabitethernet 2/0/19 stack
console(config-stack)#stack-port tengigabitethernet 2/0/20 stack
console(config-stack)#exit
console(config)#exit
5.3 PowerConnect M8428-k
5.3.1
Array and Host Port configuration:
M8428-k>
M8428-k>en
M8428-k#conf t
M8428-k (conf) #interface intengigabitethernet 0/1
M8428-k (conf-if-te-0/1) # mtu 9208
M8428-k (conf-if-te-0/1) # switchport
M8428-k (conf-if-te-0/1) # switchport mode access
M8428-k (conf-if-te-0/1) # lldp disable
M8428-k (conf-if-te-0/1) # qos flowcontrol tx on rx on
M8428-k (conf-if-te-0/1) # no shutdown
M8428-k (conf-if-te-0/1) # end
M8428-k# wr mem
Note: There is no range command available for M8428-k. So repeat the same steps for
intengigabitethernet 0/2 – 0/16 one by one.