Dell PS-M4110 Manuel - Sayfa 15

Depolama Dell PS-M4110 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PS-M4110 22 sayfaları. Blade array

Sayfayı Yazdır
Dell PS-M4110 Manuel
Create the stack on switch 2:
Put ports into stacking mode. Ports 17-20 were used as
stacking ports.
console#configure
console(config)#stack
console(config-stack)#stack-port tengigabitethernet 2/0/17 stack
console(config-stack)#stack-port tengigabitethernet 2/0/18 stack
console(config-stack)#stack-port tengigabitethernet 2/0/19 stack
console(config-stack)#stack-port tengigabitethernet 2/0/20 stack
console(config-stack)#exit
console(config)#exit

5.3 PowerConnect M8428-k

5.3.1

Array and Host Port configuration:

M8428-k>
M8428-k>en
M8428-k#conf t
M8428-k (conf) #interface intengigabitethernet 0/1
M8428-k (conf-if-te-0/1) # mtu 9208
M8428-k (conf-if-te-0/1) # switchport
M8428-k (conf-if-te-0/1) # switchport mode access
M8428-k (conf-if-te-0/1) # lldp disable
M8428-k (conf-if-te-0/1) # qos flowcontrol tx on rx on
M8428-k (conf-if-te-0/1) # no shutdown
M8428-k (conf-if-te-0/1) # end
M8428-k# wr mem
Note: There is no range command available for M8428-k. So repeat the same steps for
intengigabitethernet 0/2 – 0/16 one by one.