Dell PS-M4110 Manuel - Sayfa 14
Depolama Dell PS-M4110 için çevrimiçi göz atın veya pdf Manuel indirin. Dell PS-M4110 22 sayfaları. Blade array
Sayfayı Yazdır
console(config-if)#channel-group 1 mode auto
console(config-if)#mtu 9216
console(config-if)#exit
console(config)#interface port-channel 1
console(config-if-ch1)#mtu 9216
console(config)#exit
console# copy running-config startup-config
console#exit
Note: Repeat the same steps on the second switch
5.2.5
Stack Configuration (Non-LAG Configurations):
console#configure
console(config)#stack
console(config-stack)#stack-port tengigabitethernet 1/0/17 stack
console(config-stack)#stack-port tengigabitethernet 1/0/17 stack
console(config-stack)#stack-port tengigabitethernet 1/0/17 stack
console(config-stack)#stack-port tengigabitethernet 1/0/17 stack
console(config-stack)#exit
console(config)#exit
console# copy running-config startup-config
console#reload
Are you sure you want to reload the stack? (y/n) y
Note: On switch two, you must renumber the switch ID (default switch ID is 1). Renumber the switch to
switch ID 2 before creating and adding to the stack.
To change the switch ID number perform the following command on IO module #2:
console#configure
console(config)#switch 1 renumber 2
Are you sure you want to renumber? (y/n)y