Dell PS4110 하드웨어 사용 설명서 - 페이지 37
{카테고리_이름} Dell PS4110에 대한 하드웨어 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PS4110 48 페이지. Storage arrays
Dell PS4110에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 하드웨어 매뉴얼 (50 페이지), 개요 (7 페이지), 설치 (2 페이지)
페이지 인쇄
4 Maintaining Power Supply and Cooling Modules
The array can support two hot-swappable power supply and cooling modules.
The array can operate only temporarily with one module, but both modules must be present for long-term cooling
of the array.
About Power Supplies
The PS Series array receives power from two power supplies (PSUs).
Each PSU has a 700W power supply. Each power supply has two cooling fans.
The fans that keep the array cool are integrated into the power supply modules and cannot be replaced
separately. If a fan fails, you must replace the entire power supply module.
Identifying Power Supply Failures
You can identify a power supply and cooling module failure by any or all of the following:
•
LEDs on the power supply and cooling modules.
•
Messages on the console, in the event log, or in the Group Manager GUI Alarms panel.
•
Group Manager GUI and CLI output. The GUI Member Enclosure window or the CLI
command shows a power supply and cooling module failure.
show enclosure
When viewing the rear of the array, power supply 0 is on the right, and power supply 1 is on the left.
Note:
Power Supply LEDs
The power supplies and cooling modules have LEDs that indicate their status.
Figure 23
illustrates the power supply LEDs.
See "Power Supply LEDs" on page 33
Table 7
describes these LEDs.
for details.
member select
33