Dell Storage Center SCv2020 소유자 매뉴얼 - 페이지 34

{카테고리_이름} Dell Storage Center SCv2020에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Storage Center SCv2020 42 페이지. Storage center
Dell Storage Center SCv2020에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (19 페이지), 시작하기 매뉴얼 (20 페이지)

페이지 인쇄
Dell Storage Center SCv2020 소유자 매뉴얼
Figure 26. Replacing a Storage Controller
1.
Storage controller
7.
Locate the battery removed in a previous step and insert it into the replacement storage controller.
a. Align the battery with the slot on the storage controller.
b. Slide the battery into the storage controller until the release tab clicks into place.
8.
Insert the replacement storage controller into the chassis until it is fully seated.
9.
Reconnect all the cables to the left storage controller.
10. Push the release lever toward the chassis until it clicks into place. The storage controller is powered
on.
NOTE: When a storage controller is powered on, there is a one‐minute delay while the storage
controller prepares to boot. During this time, the only indication that the storage controller is
powered on are the LEDs on the storage controller. After the one‐minute delay, the fans and
LEDs turn on as an indication that the storage controller is starting up.
11. In the Dell Storage Client, make sure that the replacement storage controller is recognized and
shown as up and running.
NOTE: If the Storage Center software on the replacement storage controller is older than the
software on the existing storage controller, the storage system updates the replacement
storage controller with the software version on the existing storage controller. The Storage
Center software update on the replacement storage controller may take from 15 to 45 minutes
to complete.
12. Clear the swap status for the temperature sensor and I/O module.
a. Click the Hardware tab.
b. In the Hardware tab navigation pane, expand the enclosure.
c. Select Temperature Sensors.
d. In the right pane, right-click the sensor, then click Request Swap Clear.
e. Select I/O Modules.
f. In the right pane, right-click the module, then click Request Swap Clear.
g. Click the Alerts tab.
34
2.
Release lever
Replacing SCv2000/SCv2020 Components