Dell Storage Center SCv2020 소유자 매뉴얼 - 페이지 35

{카테고리_이름} Dell Storage Center SCv2020에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Storage Center SCv2020 42 페이지. Storage center
Dell Storage Center SCv2020에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (19 페이지), 시작하기 매뉴얼 (20 페이지)

페이지 인쇄
Dell Storage Center SCv2020 소유자 매뉴얼
h. Right-click the alerts for the temperature sensor and I/O modules, then click Acknowledge.
NOTE: The alerts may not appear immediately. If the alerts do not appear, wait 10 seconds
and then click Refresh.
13. Clear the swap status for the temperature sensor and acknowledge the alert.
a. Click the Hardware tab.
b. In the Hardware tab navigation pane, expand the enclosure.
c. Select Temperature Sensors.
d. In the right pane, right-click the sensor, then click Request Swap Clear.
e. Click the Alerts tab.
f. Right-click the alert and select Acknowledge.
NOTE: The alert may not appear immediately. If the alert does not appear, wait 10 seconds
and then click Refresh.
14. Shut down the other storage controller and repeat the previous steps.
Next steps
1.
Use SupportAssist to send diagnostic data to Dell Technical Support Services.

Replace Both Storage Controllers Simultaneously

If you need to replace both storage controllers at the same time, contact Dell Technical Support Services
for assistance.

Replacing Rack Rails

Rack rails are used to install the SCv2000/SCv2020 storage system into a rack.
Prerequisites
1.
Use SupportAssist to send diagnostic data to Dell Technical Support Services.
2.
Shut down the storage system using the Dell Storage Client.
About this task
Use this procedure to replace rack rails.
NOTE: Replacing rack rails must be performed during a scheduled maintenance window when the
Storage Center system is unavailable to the network.
Steps
1.
Make sure all of the cables are labeled.
2.
Disconnect all of the cables from the storage system.
3.
Remove the storage system from the rack rails.
4.
Remove the rack rails from the rack.
5.
Install the replacement rack rails in the rack.
6.
Install the storage system in the rack rails.
7.
Reconnect the cables to the storage system.
8.
Start up the storage system.
Next steps
1.
Use SupportAssist to send diagnostic data to Dell Technical Support Services.
Replacing SCv2000/SCv2020 Components
35