Dell 4605M 펌웨어 업그레이드 지침 - 페이지 4

{카테고리_이름} Dell 4605M에 대한 펌웨어 업그레이드 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 4605M 17 페이지. Emcnetworking switches

Upgrade Dell EMC Networking N1500 Series Switches

The procedure given below to download firmware to an individual switch or a stack of switches.

Please do not interrupt switch operation during the downloading process as this may result in corruption of

flash memory. Do not power off a switch undergoing the upgrade process unless specifically directed to do so

by the instructions.

NOTE:

A TFTP server must be on the network and the switch software

must be accessible to the TFTP server before attempting to download the

switch software by TFTP.

NOTE:

The following TFTP server may be used if you do not have one:

http://tftpd32.jounin.net/tftpd32_download.html

An annotated download example is shown following this section.

1. Back up your configuration.

2. Upgrade using telnet or SSH require default enable authentication method or enable password in current

configuration. If not configured follow steps below to configure an enable password:

console#configure

console(config)#enable password <password>

console(config)#exit

console#copy running-config startup-config

3. Download the 6.5.2.9 firmware image (N1500v6.5.2.9.stk) to the switch or stack master.

NOTE:

Activate the image to use as the boot (active) image after the switch

resets. Images on the N1500 series switches are named active and backup.

4. Activate 6.5.2.9 firmware.

5. Reload the switch.

6. Update boot-code.

7. Reload the switch.

Page 2