Dell C9000 series 구성 매뉴얼 - 페이지 6

{카테고리_이름} Dell C9000 series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell C9000 series 9 페이지.

Dell recommended switch configuration

Follow these steps to configure the C9000 Series chassis.

2.1

Power on the chassis.

2. Connect a serial cable to the serial port of each RPM.

3. Using PuTTY or another terminal utility, open a serial connection session to RPM 0.

4. Open your terminal emulator and configure it to use the serial port (usually COM1 but this may vary

depending on your system). Configure serial communications for 9600,N,8,1 and no flow control.

2.2

Note: This example assumes a chassis at its default configuration settings. Using the delete startup-

config command will set the startup configuration file to its default settings. You should always backup

your configuration settings prior to performing any configuration changes. The enable mode password is

calvin.

Dell>enable

Dell#delete startup-config

Proceed to delete startup-config [confirm yes/no]yes

Dell#reload

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

2.3

Dell>enable

Dell>#configure

Set the IP address for RPM 0:

Dell(conf)#interface ManagementEthernet 0/0

Dell(conf-if-ma-0/0)#ip address <ipaddress> <mask>

Dell(conf-if-ma-0/0)#no shutdown

Dell(conf-if-ma-0/0)#exit

SCG2011

Dell Networking C9000 Series Switch Configuration Guide for Dell SC Series SANs