Dell EMC S5000 설치 매뉴얼 - 페이지 33

{카테고리_이름} Dell EMC S5000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC S5000 42 페이지.

Connecting Three S5000 Systems

To provide backup connectivity and increased data transfer between the systems, Dell EMC recommends inserting an additional cable

between the two units, in a second stacking port.

CAUTION:

The S5000 does not require special stacking cables. The cables used to connect 10GbE and 40GbE data ports

are sufficient.

NOTE:

The port numbers in the following procedure are used as examples only.

1. Insert one end of the first cable into stack port 60 of chassis 1 (bottom).

2. Insert the other end of the cable into stack port 56 of chassis 2 (center).

3. Insert the second cable into stack port 60 of chassis 2 (center) and port 56 of chassis 3 (top).

4. Use the third cable to connect the top and bottom units by inserting one end of the cable into stack port 56 on chassis 1 (bottom) and

the other end of the cable into stack port 60 on chassis 3 (top).

Installation