Dell Force10 S4810 빠른 시작 매뉴얼 - 페이지 19
{카테고리_이름} Dell Force10 S4810에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4810 27 페이지. Dell force10 s4810 switch
Dell Force10 S4810에 대해서도 마찬가지입니다: 배포 매뉴얼 (36 페이지), 구성 매뉴얼 (17 페이지), 구성 매뉴얼 (17 페이지)
페이지 인쇄
Step Task
Place the interface in
2
Layer 2 (switching)
mode.
To view the interfaces in Layer 2 mode, use the show interfaces switchport
command in the EXEC mode.
Configure a Host Name
The host name appears in the prompt. The default host name is force10.
•
Host names must start with a letter and end with a letter or digit.
•
Characters within the string can be letters, digits, and hyphens.
Task
Create a new host name.
Access the System Remotely
You can configure the system to be accessed remotely by Telnet. The S4810 has
a dedicated management port and a management routing table that is separate
from the IP routing table.
Step
Task
Configure an IP address for the management port.
1
Configure a management route with a default gateway.
2
Configure a username and password.
3
Configure the Management Port IP Address
Assign IP addresses to the management ports in order to access the system
remotely.
Command Syntax
switchport
Command Syntax
hostname name
Command Mode
INTERFACE
Command Mode
CONFIGURATION
Installing the Software
15