Dell Force10 S4810 빠른 시작 매뉴얼 - 페이지 21
{카테고리_이름} Dell Force10 S4810에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4810 27 페이지. Dell force10 s4810 switch
Dell Force10 S4810에 대해서도 마찬가지입니다: 배포 매뉴얼 (36 페이지), 구성 매뉴얼 (17 페이지), 구성 매뉴얼 (17 페이지)
페이지 인쇄
Configure the Enable Password
Access the EXEC Privilege mode using the enable command. The EXEC
Privilege mode is unrestricted by default. Configure a password as a basic
security measure. There are two types of enable passwords:
•
enable password stores the password in the running/startup configuration
using a DES encryption method.
•
enable secret is stored in the running/startup configuration in using a
stronger, MD5 encryption method.
Dell Force10 recommends using the enable secret password.
Task
Create a password to
access EXEC
Privilege mode.
Create a Port-based VLAN
The Default VLAN as VLAN 1 is part of the system startup configuration and
does not require configuration. To configure a port-based VLAN, you must
create the VLAN and then add physical interfaces or port channel (LAG)
interfaces to the VLAN.
Task
Configure a port-based VLAN (if the
vlan-id is different from the Default
VLAN ID) and enter INTERFACE
VLAN mode. After you create a
VLAN, you must assign interfaces in
Layer 2 mode to the VLAN to activate
the VLAN.
Use the show vlan command in the EXEC Privilege mode to view the
configured VLANs.
Command Syntax
enable [password | secret] [level level]
[encryption-type] password
Command Syntax
interface vlan vlan-id
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
Installing the Software
17