Dell Force10 S4810 구성 매뉴얼 - 페이지 15

{카테고리_이름} Dell Force10 S4810에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S4810 17 페이지. Dell force10 s4810 switch
Dell Force10 S4810에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지), 배포 매뉴얼 (36 페이지), 구성 매뉴얼 (17 페이지)

페이지 인쇄

Note: The switch will reboot.

5.4

Configure stack on the second switch

FTOS>enable

FTOS#stack-unit 0 renumber 1

Note: The switch will reboot.

FTOS#config

FTOS(conf)#stack-unit 1 priority 1

FTOS(conf)#stack-unit 1 stack-group 12

FTOS(conf)#stack-unit 1 stack-group 13

FTOS(conf)#exit

FTOS#copy running-config startup-config

FTOS#reload

5.5

Verify stack configuration

From the first switch (Master) CLI, confirm that the stack has formed:

FTOS#show redundancy

Note: The switch front panel will show a steady light in the MASTER LED for the Master unit and a

blinking light for the Standby unit. All of the following configuration step must be performed from the

master switch.

5.6

Configure out of band (OOB) management port

FTOS#config

FTOS(conf)#interface ManagementEthernet 0/0

FTOS(conf-if-ma-0/0)#no shutdown

FTOS(conf-if-ma-0/0)#ip address ipaddress mask

FTOS(conf-if-ma-0/0)#no shutdown

FTOS(conf-if-ma-0/0)#exit

5.7

Configure route for OOB management port (optional)

FTOS(conf)#management route X.Y.Z.0 /24 A.B.C.1

Note: X.Y.Z.0 is the network your management system is connecting from and A.B.C.1 is the gateway for

the switch. If your management system is on the same subnet as the switch, the previous step may be

omitted. The example above assumes a class C subnet mask.

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs