Dell Force10 S4810 Руководство по конфигурации - Страница 15

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell Force10 S4810. Dell Force10 S4810 17 страниц. Dell force10 s4810 switch
Также для Dell Force10 S4810: Краткое руководство по эксплуатации (27 страниц), Руководство по развертыванию (36 страниц), Руководство по конфигурации (17 страниц)

Note: The switch will reboot.

5.4

Configure stack on the second switch

FTOS>enable

FTOS#stack-unit 0 renumber 1

Note: The switch will reboot.

FTOS#config

FTOS(conf)#stack-unit 1 priority 1

FTOS(conf)#stack-unit 1 stack-group 12

FTOS(conf)#stack-unit 1 stack-group 13

FTOS(conf)#exit

FTOS#copy running-config startup-config

FTOS#reload

5.5

From the first switch (Master) CLI, confirm that the stack has formed:

FTOS#show redundancy

Note: The switch front panel will show a steady light in the MASTER LED for the Master unit and a

blinking light for the Standby unit. All of the following configuration step must be performed from the

master switch.

5.6

FTOS#config

FTOS(conf)#interface ManagementEthernet 0/0

FTOS(conf-if-ma-0/0)#no shutdown

FTOS(conf-if-ma-0/0)#ip address ipaddress mask

FTOS(conf-if-ma-0/0)#no shutdown

FTOS(conf-if-ma-0/0)#exit

5.7

FTOS(conf)#management route X.Y.Z.0 /24 A.B.C.1

Note: X.Y.Z.0 is the network your management system is connecting from and A.B.C.1 is the gateway for

the switch. If your management system is on the same subnet as the switch, the previous step may be

omitted. The example above assumes a class C subnet mask.

SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs