Dell Force10 S60 Series 매뉴얼 - 페이지 14
{카테고리_이름} Dell Force10 S60 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S60 Series 45 페이지.
Dell Force10 S60 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지)
Insert Optional Modules
The S60 system has expansion slots at the front left and rear right of the system that you can use for
stacking modules or for Small Form-Factor Pluggable Plus (SFP+) devices.
modules that you can install into these expansion slots. The optional modules are hot-swappable.
NOTE: Pre-configuring the interfaces for the optical module preserves the configuration if and when you
remove an optical module. The optional 10G optical module is automatically recognized and the interfaces are
created when you insert the module into the slot. However, if the system is not already configured for the
interfaces, when you remove the optional module, the interfaces and their configurations are removed as well.
Table 3-1. Optional Modules
Module Description
2-port, 12G stacking module
1-port, 24G stacking module
2-port, 10G SFP+ optical module
WARNING: ESD damage can occur if the components are mishandled. Always wear an ESD-preventive wrist
or heel ground strap when handling the S60 system and its components.
To install an optional module, follow these steps:
Step
Task
Remove the faceplate covering the module slot located at the rear left or front right of the S60 system.
1
Remove the optional module from its packaging.
2
Slide the optional module into the slot.
3
Secure the captive screw on the side of the optional module.
4
Table 3-1
lists the optional
Install the S60 System
|
14