Dell Force10 S60 Series Podręcznik - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik dla Przełącznik Dell Force10 S60 Series. Dell Force10 S60 Series 45 stron.
Również dla Dell Force10 S60 Series: Skrócona instrukcja obsługi (29 strony)

Drukuj stronę

Insert Optional Modules

The S60 system has expansion slots at the front left and rear right of the system that you can use for

stacking modules or for Small Form-Factor Pluggable Plus (SFP+) devices.

modules that you can install into these expansion slots. The optional modules are hot-swappable.

NOTE: Pre-configuring the interfaces for the optical module preserves the configuration if and when you

remove an optical module. The optional 10G optical module is automatically recognized and the interfaces are

created when you insert the module into the slot. However, if the system is not already configured for the

interfaces, when you remove the optional module, the interfaces and their configurations are removed as well.

Table 3-1. Optional Modules

Module Description

2-port, 12G stacking module

1-port, 24G stacking module

2-port, 10G SFP+ optical module

WARNING: ESD damage can occur if the components are mishandled. Always wear an ESD-preventive wrist

or heel ground strap when handling the S60 system and its components.

To install an optional module, follow these steps:

Step

Task

Remove the faceplate covering the module slot located at the rear left or front right of the S60 system.

Remove the optional module from its packaging.

Slide the optional module into the slot.

Secure the captive screw on the side of the optional module.

Table 3-1

lists the optional

Install the S60 System