Dell Force10 S60 Series 매뉴얼 - 페이지 28

{카테고리_이름} Dell Force10 S60 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S60 Series 45 페이지.
Dell Force10 S60 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지)

페이지 인쇄
Dell Force10 S60 Series 매뉴얼

Access the Console Ports

You can access the S60 system directly through the console port at rear of the system

Access the RJ-45 Console Port (RS-232)

NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC.
The RS-232 console port is labeled on the upper right-hand side on the rear of the S60 system.
Figure 6-1. S60 Serial Console Port Connector
For the console port pin assignments, refer to
To access the RJ-45 console port, follow these steps:.
Step
Task
Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S60 console port to a
1
terminal server.
Connect the other end of the cable to the DTE terminal server.
2
Set the default terminal settings as follows:
3
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
Console
Port
Table
6-1.
6
(Figure
6-1).
Access the Console Ports
|
28