Dell Force10 S60 Series 매뉴얼 - 페이지 30

{카테고리_이름} Dell Force10 S60 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S60 Series 45 페이지.
Dell Force10 S60 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지)

페이지 인쇄
Dell Force10 S60 Series 매뉴얼
To access the USB-B console port, follow these steps:
Step
Task
Power on the PC (Dell Force 10 recommends using an XP operating system).
1
Connect the USB-A end of cable (included) into an available USB port on the PC.
2
Connect the USB-B end of cable into the USB-B console port on the S60 system.
3
Power on the S60 system.
4
Install the necessary USB device drivers (an internet connection is required). For assistance, contact Dell
5
Networking Technical Support.
Open your terminal software emulation program to access the S60 system.
6
Set the terminal connection settings as follows:
7
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
The CLI command prompt appears when you are connected to the S60 system.
8
Access the Console Ports
|
30