Dell Force10 S60 Series Manuel - Sayfa 30

Anahtar Dell Force10 S60 Series için çevrimiçi göz atın veya pdf Manuel indirin. Dell Force10 S60 Series 45 sayfaları.
Ayrıca Dell Force10 S60 Series için: Hızlı Başlangıç Kılavuzu (29 sayfalar)

Sayfayı Yazdır
Dell Force10 S60 Series Manuel
To access the USB-B console port, follow these steps:
Step
Task
Power on the PC (Dell Force 10 recommends using an XP operating system).
1
Connect the USB-A end of cable (included) into an available USB port on the PC.
2
Connect the USB-B end of cable into the USB-B console port on the S60 system.
3
Power on the S60 system.
4
Install the necessary USB device drivers (an internet connection is required). For assistance, contact Dell
5
Networking Technical Support.
Open your terminal software emulation program to access the S60 system.
6
Set the terminal connection settings as follows:
7
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
The CLI command prompt appears when you are connected to the S60 system.
8
Access the Console Ports
|
30