Dell N1148T-ON 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Dell N1148T-ON에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell N1148T-ON 27 페이지.

2 Insert the supplied bolts into the rack-mounting holes and tighten with a

screwdriver.

3 Repeat the process for the rack-mounting bracket on the other side of the

switch.

4 Insert the switch into the 48.26 cm (19 inch) rack, ensuring that the rack-

mounting holes on the bracket line up with the mounting holes in the

rack.

5 Secure the bracket to the rack with either the rack bolts or cage nuts and

cage-nut bolts with washers (depending on the kind of rack you have).

Fasten the bolts on the bottom before fastening the bolts on the top.

CAUTION:

rack.

NOTE:

Make sure that the ventilation holes are not obstructed.

Wall Installation for N1108T-ON and N1108P-ON

To mount the switch on a wall:

1 Make sure that the mounting location meets the following requirements:

•

The surface of the wall must be capable of supporting the switch.

•

Allow at least two inches (5.1 cm) space on the sides for proper

ventilation and five inches (12.7 cm) at the back for power cable

clearance.

•

The location must be ventilated to prevent heat buildup.

2 Place the supplied wall-mounting bracket on one side of the switch,

verifying that the mounting holes on the switch line up to the mounting

holes on the wall-mounting bracket.

Getting Started Guide

Make sure that the supplied rack bolts fit the pre-threaded holes in the