Dell N1148T-ON 시작하기 매뉴얼 - 페이지 11

{카테고리_이름} Dell N1148T-ON에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell N1148T-ON 27 페이지.

Figure 1-4. Bracket Installation for Wall Mounting

3 Insert the supplied screws into the wall-mounting bracket holes and

tighten with an M5x32 screwdriver.

4 Repeat the process for the wall-mounting bracket on the other side of the

switch.

5 Place the switch on the wall in the location where the switch is being

installed.

6 On the wall mark the locations where the screws to hold the switch must

be prepared.

7 On the marked locations, drill the holes and place all plugs (not provided)

in the holes.

8 Secure the switch to the concrete wall or wood material with screws (not

provided). Make sure that the ventilation holes are not obstructed.

Installing as a Free-standing Switch

NOTE:

Dell strongly recommends mounting the switch in a rack.

Install the switch on a flat surface if you are not installing it in a rack. The

surface must be able to support the weight of the switch and the switch

cables. The switch is supplied with four self-adhesive rubber pads.

1 Attach the self-adhesive rubber pads on each location marked on the

bottom of the switch.

Getting Started Guide