Dell N2000 Series 매뉴얼 - 페이지 15

{카테고리_이름} Dell N2000 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell N2000 Series 17 페이지. Switch dell networking n2000 series
Dell N2000 Series에 대해서도 마찬가지입니다: 펌웨어 업그레이드 (21 페이지)

페이지 인쇄
Dell N2000 Series 매뉴얼
console(config-telnet)#login authentication default
console(config-telnet)#exit
console(config)#ip http authentication local
console(config)#username admin password yourpassword privilege 15
console(config)#enable password yourpassword
3.3

Enable iSCSI optimization feature

This feature, enabled by default, is activated when EqualLogic arrays are detected, however, Dell
recommends manually configuring these steps too. It automatically performs the following:
Configures jumbo frames to 9216 on all ports.
Disables unicast storm.
Enables spanning tree portfast on ports connected to EqualLogic arrays.
Configures flow control on all ports.
Note: Spanning tree portfast must be manually configured for host facing ports. Refer to Section 3.6.
console#configure
console(config)#iscsi enable
Enabling iSCSI Optimization will enable Flow Control which may cause all the
interfaces to temporarily go down.
Are you sure you want to continue? (y/n) y
console(config)#exit
3.4

Enable flow control

Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon
detection of an EqualLogic Array. Dell recommends also manually configuring this step.
console#configure
console(config)#flowcontrol receive on
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to continue? (y/n)y
console(config)#exit
15
SCG1015
Dell Networking N2000 Series Configuration Guide