Dell N2000 Series Manual - Page 15

Browse online or download pdf Manual for Switch Dell N2000 Series. Dell N2000 Series 17 pages. Switch dell networking n2000 series
Also for Dell N2000 Series: Firmware Upgrade (21 pages)

Print Page

console(config-telnet)#login authentication default

console(config-telnet)#exit

console(config)#ip http authentication local

console(config)#username admin password yourpassword privilege 15

console(config)#enable password yourpassword

3.3

Enable iSCSI optimization feature

This feature, enabled by default, is activated when EqualLogic arrays are detected, however, Dell

recommends manually configuring these steps too. It automatically performs the following:



Configures jumbo frames to 9216 on all ports.



Disables unicast storm.



Enables spanning tree portfast on ports connected to EqualLogic arrays.



Configures flow control on all ports.

Note: Spanning tree portfast must be manually configured for host facing ports. Refer to Section 3.6.

console#configure

console(config)#iscsi enable

Enabling iSCSI Optimization will enable Flow Control which may cause all the

interfaces to temporarily go down.

Are you sure you want to continue? (y/n) y

console(config)#exit

3.4

Enable flow control

Note: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upon

detection of an EqualLogic Array. Dell recommends also manually configuring this step.

console#configure

console(config)#flowcontrol receive on

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to continue? (y/n)y

console(config)#exit

SCG1015

Dell Networking N2000 Series Configuration Guide