Dell Networking S4810 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Dell Networking S4810에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S4810 16 페이지. Open networking
Dell Networking S4810에 대해서도 마찬가지입니다: 사양 (2 페이지), 구성 매뉴얼 (17 페이지), 설치 매뉴얼 (42 페이지), 구성 매뉴얼 (17 페이지)

페이지 인쇄

CAUTION: Grounding conductors must be made of copper. Do not use aluminum conductors.

NOTE: Coat the one-hole lug with an anti-oxidant compound prior to crimping. Bring any unplated

mating surfaces to a shiny finish, and coat with an anti-oxidant prior to mating. Plated mating

surfaces must be clean and free from contamination.

Cut the ground cable to the desired length. The cable length must facilitate the proper operation of

fault interrupt circuits. Dell Networking recommends using the shortest cable route allowable.

Attach the one-hole lug to the chassis using an M4x0.7 screw with a captive internal tooth lock

washer, as shown. Torque the screw to 20 in-lbs.

Figure 3. Attach the Ground Cable

Attach the other end of the ground cable to a suitable ground point.

Important Points to Remember

The S4810–ON is designed to support two hot-swappable power supplies with integrated fans that

provide cooling for the chassis.

•

The PSU slides into the slot smoothly. Do not force the PSU into a slot as this action may damage the

PSU or the S4810–ON chassis.

•

The S4810–ON supports AC power supplies with two air-flow directions (I/O to Utility and Utility to

I/O). The S4810–ON does not support mixing PSU types. The fan airflow direction for both the PSUs

must be the same.

WARNING: Although the switch can run on one PSU, Dell Networking highly recommends using

two PSUs for full redundancy and proper cooling. To avoid overheating if the switch needs to run

with only one PSU for a time, Dell Networking recommends using PSU1 (on the left) and covering

the second PSU slot opening with a blank plate.

WARNING: The Utility panel consists of four slots numbered from 1 to 4. Insert PSUs in slots 1 and

WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-

preventive wrist or heel ground strap when handling the S4810–ON and its components.

WARNING: DO NOT mix airflow directions. Both power supplies must use the same airflow

direction (I/O to Utility or Utility to I/O).

WARNING: To prevent electrical shock, ensure the S4810–ON is grounded properly. If you

ground your equipment incorrectly, excessive emissions may result. To ensure the power cables

meet your local electrical requirements, use a qualified electrician.

Install the Hardware