Dell Networking S5000 구성 매뉴얼 - 페이지 10

{카테고리_이름} Dell Networking S5000에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S5000 12 페이지. Data center switch
Dell Networking S5000에 대해서도 마찬가지입니다: 설치 매뉴얼 (50 페이지), 구성 매뉴얼 (17 페이지), 시작하기 매뉴얼 (37 페이지)

페이지 인쇄

Configure UPM ports as Ethernet pass-through (optional)

The FC ports on the Unified Port Module (UPM) can be configured as Ethernet pass-through. Use this

section only if the UPM module is used. The 12 ports are divided into six port groups numbered 0-5. Two

ports in each port group can be configured separately as FC or Ethernet pass-through.

Note: This operation requires a reload for the changes to take effect.

3.1

View the current configuration

Use this command to view the current mode of the ports and also the port group mapping.

FTOS#

show system

PortGroupId

3.2

Configure port group 0 as Ethernet pass-through

FTOS(conf)# stack-unit 0 port-group 0 portmode Ethernet

Changing port mode on slot 0 port-group 0 will make interface configs of 0 and 1

obsolete after a save and reload.

[confirm yes/no]:yes

Please save and reload for the changes to take effect.

Note: Save and reload is required.

SCG2004

Dell Networking S5000 Switch Configuration Guide for SC Series SANs

stack-unit

0 port-group portmode

Ports

Mode(Curr Boot) Mode(Next Boot)

0,1

2,3

4,5

6,7

8,9

10,11