Dell Networking S6000 System 시작하기 매뉴얼 - 페이지 12
{카테고리_이름} Dell Networking S6000 System에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S6000 System 37 페이지. Dell networking s6000 high-performance 10/40 gbe top-of-rack switch
Dell Networking S6000 System에 대해서도 마찬가지입니다: 테스트 보고서 (19 페이지)
페이지 인쇄
WARNING: Electrostatic discharge (ESD) damage can occur if components
are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the S6000 and its components.
CAUTION: To prevent electrical shock, ensure the S6000 is grounded
properly. If you ground your equipment correctly, excessive emissions may
result. To ensure the power cables meet your local electrical requirements, use
a qualified electrician.
Fans
The S6000 supports three hot-swappable fans that provide cooling for the
system. The S6000 has stock keeping units (SKUs) that support the following
configurations. Installation of the fans is done as part of the factory install based
on SKU type. The PSUs are installed at the customer site (refer to
Supplies).
•
AC PSU with fan airflow from I/O to PSU
•
AC PSU with fan airflow from PSU to I/O
•
DC PSU with fan airflow from I/O to PSU
•
DC PSU with fan airflow from PSU to I/O
All fans and PSUs in a configuration must be in the same airflow direction.
Should a mixed airflow configuration happen, the software notifies you of the
invalid configuration.
The S6000 supports three fan trays with airflow directions from I/O to Utility or
Utility to I/O. The PSU airflow directions are indicated with stickers on PSUs.
8
Hardware Overview
Power