Dell Networking Z9500 시작하기 매뉴얼 - 페이지 6

{카테고리_이름} Dell Networking Z9500에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking Z9500 34 페이지. Z9500 switch
Dell Networking Z9500에 대해서도 마찬가지입니다: 설치 매뉴얼 (47 페이지)

페이지 인쇄

•

The switch is installed in an environment as free as possible from dust and foreign conductive material

(such as metal flakes from construction activities). Cooling mechanisms, such as fans and blowers in

the switch, can draw dust and other particles causing contaminant buildup inside the chassis, which

can result in system malfunction.

•

The Z9500 switch does not support installation in a 1070 mm cabinet with a door.

•

To install the switch, Dell Networking recommends that you complete the installation procedures in

the order presented below.

NOTE: Always handle the system and its components with care. Avoid dropping the chassis or its

field replaceable units.

NOTE: For proper ventilation, position the chassis in an equipment rack (or cabinet) with a

minimum of 5 inches (12.7 cm) of clearance around exhaust vents. The acceptable ambient

temperature ranges are listed in the Environmental Parameters section.

CAUTION: Always wear an ESD-preventive wrist or heel ground strap when handling the

switch and its components. Ground yourself by using an antistatic wrist strap or other device

and connect it to the ESD grounding jack on the chassis. As with all electrical devices of this

type, take all necessary safety precautions to prevent injury when installing this system.

Assemble 4–Post Rack Frame

The chassis can be installed only in a 4–post rack frame.

Follow the instructions in your rack frame kit to install the 4–post rack frame.

Getting Started Guide