Dell Networking Z9500 설치 매뉴얼 - 페이지 29

{카테고리_이름} Dell Networking Z9500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking Z9500 47 페이지. Z9500 switch
Dell Networking Z9500에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (34 페이지)

페이지 인쇄
Dell Networking Z9500 설치 매뉴얼
The fan modules are field replaceable. Module slot 0 is on the left side of the chassis; module slot 4 is on
the right side of the chassis.
1.
Take the fan module out of the shipping box.
2.
Use the grab handle to slide the fan module into the switch fan slot, as shown below.
Figure 7. Installing a Fan Module
1.
Release latch

Installing AC Power Supplies

The chassis requires four power supplies to be installed for normal configuration. The airflow direction
must be from I/O to Utility.
Important Points to Remember for Installing an AC Power Supply
•
The power supply unit (PSU) slides into the slot smoothly. Do not force a PSU into a slot as this action
may damage the PSU or the chassis.
•
The chassis supports AC power supplies with air-flow direction from I/O to Utility.
•
For PSUs, a LED indicates the power status.
•
To view the log messages, use the show logging command. For more information, refer to the
System Logs chapters of the Dell Networking OS Command Line Reference Guide for the Z9500
Switch and Dell Networking OS Configuration Guide for the Z9500 Switch.
WARNING: Although the switch can run on two PSUs, Dell Networking requires using four PSUs
for full redundancy and proper cooling.
WARNING: The Utility panel consists of four slots numbered from 0 to 3. Insert PSUs in slots 0, 1,
2, and 3.
WARNING: The PSU edge connector is at the bottom. Avoid installing the PSU upside down.
Z9500 Installation
2.
Fan module 0/Slot 0
29