Dell PowerConnect 2224 사용자 설명서 - 페이지 6

{카테고리_이름} Dell PowerConnect 2224에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 2224 24 페이지. Technical specifications update for the dell powerconnect 2200/2300 series ethernet switches
Dell PowerConnect 2224에 대해서도 마찬가지입니다: 사용자 설명서 (38 페이지), 기술 사양 업데이트 (2 페이지)

페이지 인쇄

1. Connecting Devices

Table 1-1. Tag-Based Prioritization

IEEE 802.1p Priority Priority Queue Scheduling Weight

0-3

4-7

NOTE:

The IEEE 802.1p priority information is part of the IEEE 802.1q tag that also defines VLAN memberships. The switches will ignore the VLAN

membership information in the tag (that is, all ports are part of all VLANs), but will preserve the full tag information—including packet priority and

VLAN ID— when transmitting the packet at the destination port.

Mounting Kit Instructions

The switches come with mounting brackets and screws for rackmounting or wallmounting and rubber feet for stationing on a flat surface.

Installing the Switch on a Flat Surface

The switch can be installed on any appropriate level surface that can safely support the weight of the switches and their attached cables. There must be

adequate space around the switch for ventilation and access to cable connectors.

To install the switch on a flat surface, complete the following steps:

1. Set the switch on the flat surface and check for proper ventilation.

Allow at least 5.1 cm (2 inches) on each side for proper ventilation and 12.7 cm (5 inches) at the back for power cable clearance.

2. Attach rubber feet on each marked location on the bottom of the chassis.

The rubber feet are optional, but are recommended to keep the switch from slipping.

Installing the Switch in a Rack

The switch can be installed in Dell PowerEdge™ racks, which are 48.3 cm (19 inches). It can also be installed in most other standard 19-inch racks and most

telco two-post racks.

NOTE:

Do not install rubber feet on the switch if you are rackmounting the switch.

To install the switch in a rack, complete the following steps:

1. Use the supplied screws to attach a mounting bracket to each side of the switch (see Figure 1-7).

Figure 1-7. Brackets for Rack Installation