Dell PowerConnect 2608 사용자 설명서 - 페이지 10

{카테고리_이름} Dell PowerConnect 2608에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 2608 38 페이지. Powerconnect 26 series
Dell PowerConnect 2608에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지)

페이지 인쇄

Mounting Kit Instructions

These switches come with mounting brackets and screws for rackmounting or wallmounting and

rubber feet for stationing on a flat surface.

Installing the Switch on a Flat Surface

The switch can be installed on any appropriate level surface that can safely support the weight of

the switches and their attached cables. There must be adequate space around the switch for

ventilation and access to cable connectors.

To install the switch on a flat surface, complete the following steps:

Set the switch on the flat surface and check for proper ventilation.

Allow at least 5.1 cm (2 inches) on each side for proper ventilation and 12.7 cm (5 inches) at

the back for power cable clearance.

Attach rubber feet on each marked location on the bottom of the chassis.

The rubber feet are optional, but are recommended to keep the switch from slipping.

Installing the Switch in a Rack

The switch can be installed in Dell PowerEdge™ racks, which are 48.3 cm (19 inches). It can also be

installed in most other standard 19-inch racks and most telco two-post racks.

NOTE:

Do not install rubber feet on the switch if you are rackmounting the switch.

To install the switch in a rack, complete the following steps:

Use the supplied screws to attach a mounting bracket to each side of the switch (see

Figure 1-5).

Introduction