Dell PowerConnect 2608 Kullanıcı Kılavuzu - Sayfa 10
Anahtar Dell PowerConnect 2608 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dell PowerConnect 2608 38 sayfaları. Powerconnect 26 series
Ayrıca Dell PowerConnect 2608 için: Kullanıcı Kılavuzu (21 sayfalar)
Sayfayı Yazdır
Mounting Kit Instructions
These switches come with mounting brackets and screws for rackmounting or wallmounting and
rubber feet for stationing on a flat surface.
Installing the Switch on a Flat Surface
The switch can be installed on any appropriate level surface that can safely support the weight of
the switches and their attached cables. There must be adequate space around the switch for
ventilation and access to cable connectors.
To install the switch on a flat surface, complete the following steps:
Set the switch on the flat surface and check for proper ventilation.
1
Allow at least 5.1 cm (2 inches) on each side for proper ventilation and 12.7 cm (5 inches) at
the back for power cable clearance.
Attach rubber feet on each marked location on the bottom of the chassis.
2
The rubber feet are optional, but are recommended to keep the switch from slipping.
Installing the Switch in a Rack
The switch can be installed in Dell PowerEdge™ racks, which are 48.3 cm (19 inches). It can also be
installed in most other standard 19-inch racks and most telco two-post racks.
NOTE:
Do not install rubber feet on the switch if you are rackmounting the switch.
To install the switch in a rack, complete the following steps:
Use the supplied screws to attach a mounting bracket to each side of the switch (see
1
Figure 1-5).
10
Introduction