Dell PowerConnect 28 SERIES 시작하기 매뉴얼 - 페이지 12

{카테고리_이름} Dell PowerConnect 28 SERIES에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 28 SERIES 22 페이지.

Starting and Configuring the Device

After completing all external connections, proceed as follows:

•

If the device is to be used as an unmanaged switch, there is no need for a terminal connection.

•

A terminal connection is useful if the device is to be used in a managed mode.

NOTE:

Before proceeding, read the release notes for this product. The release notes can be downloaded

from http://support.dell.com.

NOTE:

It is recommended that you obtain the most recent revision of the user documentation from the Dell

support website at http://support.dell.com.

The PowerConnect 2808/16/24/48 has a Mode push button on the front panel. The Mode button

changes between Managed and Unmanaged modes, or changes from Secure to Managed modes.

To connect to an uplink port, use Category 6 Shielded Twisted-Pair (STP) cables with RJ-45

connectors at both ends. The RJ-45 ports on the Ethernet device support automatic Media-

Dependent Interface/Media-Dependent Interface with internal crossover wiring (MDI/MDIX).

Standard straight-through twisted-pair cables can be used to connect to any other Ethernet

network (systems, servers, switches or routers).

NOTICE:

Do not plug a phone jack connector into an RJ-45 port. This will damage the Ethernet device. Use

only twisted-pair cables with RJ-45 connectors that conform with FCC standards.

To connect the device to the network:

1 Attach one end of a Twisted-Pair cable to the device's RJ-45 connector and the other end to a

switch or server.

2 Make sure each twisted pair cable does not exceed 328 feet (100 meters) in length.

As each connection is made, the link LED corresponding to each port on the device is illuminated

(green or amber) indicating that the connection is valid.

Starting and Configuring the Device