Dell PowerConnect 28 SERIES 시작하기 매뉴얼 - 페이지 13

{카테고리_이름} Dell PowerConnect 28 SERIES에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 28 SERIES 22 페이지.

Connecting the Terminal to the Device

The device provides an external console port in models 2816/24/48. The console port enables a

connection to a terminal desktop system running terminal emulation software for monitoring and

configuring the device.

The Console port connector is a male DB-9 connector, implemented as a data terminal equipment

(DTE) connector.

To use the Console port, the following is required:

•

VT100 compatible terminal or a desktop or portable system with a serial port and running VT100

terminal emulation software.

•

An RS-232 null-modem cable with a female DB-9 connector for the Console port and the

appropriate connector for the terminal.

To connect a terminal to the device Console port, perform the following:

1 Connect the supplied RS-232 crossover cable to the terminal running VT100 terminal emulation

software.

2 Ensure that the terminal emulation software is set as follows:

Select the appropriate serial port to connect to the console.

Set the data rate to 9600 baud.

Set the data format to 8 data bits, 1 stop bit, and no parity.

Set flow control to none.

Select VT100 for Emulation mode.

NOTE:

When using HyperTerminal with Microsoft® Windows 2000, Windows XP, or Windows Vista, ensure that

you have the latest service packs installed. With Windows 2000 Service Pack 2, the arrow keys function properly in

HyperTerminal's VT100 emulation. Go to www.microsoft.com for information on Windows 2000, Windows XP, and

Windows Vista service packs.

3 Connect the female connector of the RS-232 crossover cable directly to the Console port on the

device, and tighten the captive retaining screws. The PowerConnect 2800 series Console port is

located on the back panel.

The procedure described in this section refers to the device when set to operate as a managed switch.

The PowerConnect 2808/16/24/48 models include a built-in dual purpose Mode Button. To change

between managed and unmanaged modes, press the Mode Button for less than seven seconds.

Once the device is set to operate as a managed switch the boot procedure can be monitored on the

connected terminal as follows:

1 Ensure that the device console port is connected to a VT100 terminal device or VT100 terminal

emulator via the device's RS-232 crossover cable.

Starting and Configuring the Device