Dell PowerConnect 7024P 펌웨어 업그레이드 - 페이지 17

{카테고리_이름} Dell PowerConnect 7024P에 대한 펌웨어 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 7024P 24 페이지. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect 7024P에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지)

페이지 인쇄

Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or

4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware

have a non-default enable authentication method defined (e.g. TACACS),

setting an enable password allows one to access privileged exec (enable)

mode after the firmware upgrade.

3. Download the 5.1.9.3 firmware to the switch or stack master. The following versions are available:

- PCM6220v5.1.9.3.stk

- PC7000_M6348v5.1.9.3.stk

- PC8024v5.1.9.3.stk

- PCM8024v5.1.9.3.stk

4. Activate 5.1.9.3 firmware.

5. Update the boot code from the CLI after performing steps 1 through 4 above. If the update bootcode

command does not boot the switch automatically, reload the switch. The upgrade procedure will take

several minutes to complete for an individual switch and longer for a stack of switches.

NOTE:

After upgrading to the 5.1.9.3 firmware, one can emulate the earlier

firmware default behavior for privileged exec (enable) mode access by

setting the enable authentication method to enableList.

console(config)# line telnet

console(config)# enable authentication enableList

console(config)# exit

Upgrade Example for Switches Running v2.x.x.x Firmware

This example shows an annotated upgrade example for a PCM6220 switch running 2.2.0.3 firmware. This example

presumes the administrator is logged in to the switch or stack via telnet or SSH. If following this example, be sure to

use the firmware appropriate to the switch being upgraded.

NOTE:

A TFTP server must be on the network and the switch software

must be accessible by the TFTP server before attempting to download

the switch software by TFTP.

NOTE:

The following TFTP server may be used if you do not have one:

http://tftpd32.jounin.net/tftpd32_download.html

1. Back up your configuration.

console#copy running-config tftp://10.10.10.200/myconfig.txt

Mode........................................... TFTP

Set TFTP Server IP............................. 10.10.10.200

TFTP Path...................................... ./

TFTP Filename.................................. myconfig.txt

Data Type...................................... Config Script

Source Filename................................ running-config

Management access will be blocked for the duration of the transfer

Are you sure you want to start? (y/n) y

11062 bytes transferred

File transfer operation completed successfully.

console#

Page 14